Acano Solution Instalační příručka Strana 31

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 94
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 30
Dial Plan Configuration SIP Endpoints
Acano solution: Deployment Guide R1.2 76-1006-06-K
Page 31
5.2 SIP Endpoints Dialing a Call on the Acano Solution
As a starting point, consider using only SIP video endpoints and the configuration on the VCS
and Acano solution to direct and host calls for these endpoints.
Figure 6: Example of SIP video endpoints calling into an Acano Server hosted calls
5.2.1 SIP call control configuration
This example assumes the SIP Call Control is a Cisco VCS but similar steps are required on
other Call Control devices.
Set up a zone to route calls to the Acano solution by logging into the VCS as an administrator
and following the steps below.
1. Go to VCS Configuration > Zones > New.
2. Create the zone with the following:
H.323 Mode = Off.
SIP Mode = On
SIP Port = 5060 (5061 if using TLS)
SIP Transport = TCP or TLS, as appropriate
SIP Accept Proxied Registrations = Allow
Authentication Policy = Treat as authenticated
SIP Authentication Trust Mode = Off
Peer 1 Address = the IP address of the Call Bridge
Zobrazit stránku 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 93 94

Komentáře k této Příručce

Žádné komentáře